VOOPOO Drag Mini Mod Instructions - Vape Guide
More instructions
A. Sleep Mode
Screen will auto turn off in 30s without operations, and will enter standby mode in 30min without operations/usage after screen is turned off. To activate, press power buttonB. Charging Mode :
The device will enter charging state with the battery icon running when it's connected to 5V power supply with USB cable; when the device is fully charged, the battery icon will stop running.Note: It takes 2 hours to fully charge the device (5A/2V charger required)
C. Computer customization
You can do the following customization operations via the VOOPOO Firmware Prompt page, Temperature coefficient, Temperature curve, Wattage Curve, Increase /Decrease Coil type and Device Upgrade etc
Download address: http://www.voopootech.com
D. Function tips:
E. Accommodation coefficient of the TC wire : 
Note:
1. The higher coil coefficient you set, the higher coil temperature you get;
2. Because of the different material for the wire, you may feel the power is not strong enough when vaping, you can properly adjust the coil coefficient at a higher rate to get a better vaping experience;
3. Please adjust the coil coefficient at a low rate, if too high there is a risk of firing cotton.
No comments