Designed For Flavor -- asMODus Galatek

The bottom airflow system is always for flavor. The high temperature is the deficit for the RDA because it is not so good for heat radiation.

There is some other RDA comes with the radiation features. Asmodus is one of them.

Package

The Asmodus has a concise package with only two boxes in small size. Even this, All items needs are in the packing list. Except for the RDA, there are screwdriver, Clapton wires, back up O-rings, screws, and BF screws.

Appearance

Having a look at the RDA, we can easily get why it is called asMODus Galatek. There are four colors available. Here I am going to share the black one with you. The craftsmanship for the paintwork is not familiar to me, but it is stable with a knife, only a slight snatching left.

The RDA is in the bullet shape with the bottom part connect the cube in a curved shape. The upper part turned into the cylinder. The cube is why it is called GALATEK. The cube divide into 2 part for inner and exterior. On the exterior part, there are four arches, two of which faces the air-in slot. In combination, it displays a funny face.

The material of the drip tip is unknown. Because of the umbels structure, the tank is good for heat isolation. Even it has an 810 connector, the exterior for the drip tip is plastic, in other words, the 810 connector has an inter-ring.

The atomizer has two parts with the exterior and interior one. For the internal one, it has a high craved, which increases the concentration of the cloud. The paint for the inter can is much more smooth than the exterior. On the bottom of the can is the airflow system. You can rotate the air-in volume.

The exterior part is thin and responsible for isolation and heat radiation. On the base deck, there is a pole which is a not common pole. The design for the pole makes the clouds would not stop by the pole and cotton. It leads to a pure flavor. The air-in holes keep a long distance to avoid too much juice for leaking. Even the juice slot is 4mm in height, but the air-in occupied the space. Comparing with the side airflow system, it has a smaller capacity.

The distance for the poles is 6mm which is suit for the fanciest wires. When installing the cotton, you have to be careful to avoid the cotton right above the air-in hole. If not, it is easy to get the juice to the air-in hole.

The fancy wires in the package have the best performance on the Mech mod with the dense clouds and rich flavor. Comparing with the common the wires, the performance of the fancy wires is just so-so. Also, for other wires, if I build the fancy wires, none of them has a great performance. The single coils have a great performance.

With the small space for inner can, so the higher heating and low resistance wires are not recommended. When a large size wires for coil building, you have to take care of the height of the coil and distance to the exteriors to avoid the short circuit.

Even it needs to practice getting used to coil building. The RDA has a great performance on flavor and clouds. It makes the best use of the space to mix the clouds and air in higher percentage and concentrate the gas in the best way. It has a rich flavor, dense clouds, and adjustable airflow system. Also, it is good to against concentrate. It is a great bottom airflow system RDA.